![]() Sets the ServerAddress to the IP address of the TFTP server Set the DestinationFileType to networkfile ![]() Please remember to use the ReadWrite Community for your devices. The shown command line syntax was taken from NET-SMP 5.4.1. ![]() You need SNMP Write Access at the device and a device where you can use the snmpset command. This is a step by step guide on how to save the running-config on a TFTP Server. If you also know your way around scripting (Shell, Perl or whatever you prefer) this is how you could save your devices automatic. I recommend you first go through the FTP protocol before you start learning about the TFTP protocol in detail.Saving the configurations from Cisco Devices is normally done by a tool (CW2k, Solarwinds Cirrus or whatever) but if you do not want to buy a tool here’s a way to do it yourself.Ĭisco has a SNMP MIB called CISCO-CONFIG-COPY-MIB.oid which allows to save the configurations from Cisco devices over SNMP. It is a simple protocol that is based on the UDP protocol and is used to transfer files between hosts on a network. TFTP is a file transfer protocol that is commonly used in computer networks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |